1jz-gte, 2jz-gte vvti or non vvti to Nissan 350z, Infinity G35 (CD009 also named JK), 370z or G37 (CD00A) transmission adapter plate kit.
There are 3 different bearing size and you need to select the right now when you order. Check picture below.
-1 Item Items
Warning: Last items in stock!
Read all the description carefully.
You'll need to cut the CD009 Bellhousing to bolt this kit to the transmission.
1. This adapter require a Toyota J1 (SC300 automatic or 1jz vvti) or J3 (2jz automatic transmission) bellhousing from an a430 automatic transmission.
Why? Because this bellhousing is much smaller than the factory CD009 bellhousing (much easier to fit in the transmission tunnel) and does not require a special custom flywheel$$$!
With the J1 adapter a W58 2jz flywheel and pressure plate is required. This means, if you're running a 2jz with an w58 transmission (5 spd) you can reuse the flywheel AND the pressure plate. The only part to change in your clutch kit is the clutch disc. We can supply brand new flywheel and clutch kit.
With the J3 bellhousing, a W55 (IS300 manual) flywheel is required. The W55 flywheel is much thicker than the W58 flywheel. Pressure plate can be a W55 or W58. We can supply brand new flywheel and clutch kit.
We can supply the bellhousing. We have few in stock. Contact us.
The single clutch disc option is good for around 450-500 lb/tq.
If you need more, we have few twin plate custom make clutch that can hold up to 1300 lb/tq that included everything needed (flywheel, alignement tool, slave, flywheel crank bolts).
3. All the required bolts, seal and gasket and pilot bearing (bushing) are included.
4. AN4 hydraulic line adapter for the T56 slave cylinder is included. Clutch line is not included.
What is missing:
1. A solution to get the shifter at the right place. We have the Serial Nine CD999 Relocation kit that fit perfectly on a Toyota Supra MKIV. Distance is ajustable 29.5"-33.5" from engine face*
(5" to 9"shorter than OEM Nissan distance)
2. A custom drive shaft (we can supply 1350 steel or aluminium driveshaft) OR we can supply the slip yoke and you can build a custom driveshaft by your local driveshaft specialist. We also have the differential 3 bolts to 1350 adapter plate . Contact us!
3. Clutch kit! We offer ACT 6 puck sprung clutch disc with ACT Xtreme Pressure plate or a custom Xclutch USA twin plate rated for 1300 lb/tq
4. Transmission crossmember. We can supply a polyeurethane mount so you can adapt it easily with your crossmember.
5. A master cylinder for the clutch MIGHT be required. The T56 slave cylinder is pretty big and requires a lot of oil. Factory slave cylinder might now work well. We can supply a Wilwood 7/8″ master cylinder.
6. Clutch hose that goes from the clutch master cylinder to the slave cylinder. The adapter kit comes with a fitting that is AN4 male.
The adapter is CNC Machined out of billet 6061-T6 Aluminum.
How to measure transmission bearing size and identify transmission: